Reason For Project Stall

[crunchysteve]

Hi all (any?),

Late last year, my mother-in-law died, and this year has seen a few changes in the workshop (which is frankly an utter mess), so I apologise for stalled development. I've also been dealing with a few health issues and helping out a friend whose health issues make my look like common cold.

I'm soon to be cleared for heavy lifting again, so hopefully, workshop organising and studio setup will improve in the next few months to a point where I can resume this project. I have some firm targets and a desire to get this beast running. I also have a new, reliable Anycubic Kobra S1 printer, so hardware dev should speed up a lot, too.

Meanwhile, if you have suggestions or actually coded improvements, lodge your issues or pull requests, respectively.

Cheers,
"Crunchy"