LED control via DShot

[stylesuxx]

LED control is currently only possible through config, should also be possible via DShot commands.

[edermi]

How can I enable / configure this currently with BlueJay? I have a T1 Ranger and the used ESCs apparently have a LED I'd like to turn on.

[stylesuxx]

On specific layouts you can set the LEDs via configurator, yes. If you link the ESC, I should be able to tell you with more confidence...

[edermi]

Should be this https://www.heewing.com/products/hee-wing-rc-t1-ranger-vtol-fx-25a-upgraded-2022-2023-esc

According to https://youtu.be/e_ng6lvXPlw there's an LED, he's using the BLHeli configurator to turn it on

[stylesuxx]

Unfortunately it does not say which layout this is, but if it works in blheli_S it should work on Bluejay too.

[edermi]

That's my hope 🙂
Can I use the same software for configuration?

[stylesuxx]

You'd use https://esc-configurator.com

[Meta-Cake]

I also have an ESC with an LED on it, ironically, it is also from the HeeWing T1. I flashed bluejay to them, but I don't see any options on https://esc-configurator.com/ to configure or modify them. Is there something special that needs to be done to enable this functionality on my part or does it just come down to specifically adding each ESC with an LED on it.

[stylesuxx]

If it's the correct layout, the option should be there. Which layout does it show?

[Meta-Cake]

It is showing J-H-30 whenever I read the settings back

[stylesuxx]

J layout has LEDs. Can you switch to individual settings mode in the configurator please and see if the setting shows up?

[Meta-Cake]

It showed up! Thank you, I didn't even realize there was an individual option in the configurator. It might help some other people if there were a little note where the option should be that said, "This ESC supports LEDs; to configure them, select 'Disable common settings' in the settings menu," or something similar