The current hardware revision is v1.1. Print from hardware/plastics/v1.1 (the v1.0 files remain for anyone who already built one).
- Stronger pull (11 lb → 15 lb) — a smaller-diameter MK8 drive gear replaces the MK7.
- Fewer parts — each arm now uses one larger 633ZZ bearing (3 × 13 × 5 mm) instead of two small bearings.
- Pre-cut PTFE tubes — tubes now ship pre-cut to 10 / 40 / 70 mm (two of each), so there's no measuring or razor-cutting during the build.
The plastics changed slightly to suit the new tube lengths; otherwise assembly is the same.
Image build guide can be found here.
Video build guide can be found here.
Video installation guide can be found here.
You can purchase a kit here that includes all of these parts.
Or you can source the parts below.
| Item | Quantity |
|---|---|
| PCB | 1 |
| Motor | 1 |
| 24V 1.5A Power adapter | 1 |
| Cable extension | As needed |
| 3M Command Strips | 4 |
| Rope | 30ft |
| PTFE Tubing (pre-cut: 2×10mm, 2×40mm, 2×70mm) | 6 |
| M3 Square Nut | 4 |
| M3x35mm Button Head Screw | 3 |
| V-Groove Pulley | 1 |
| M3x10mm Flat Head Screw | 2 |
| M3x15mm Button Head Screw | 3 |
| 633ZZ Bearing (3×13×5mm) | 2 |
| MK8 Drive Gear | 1 |
| Zip Tie | 4 |
| M3x10mm Thread Forming Screw | 23 |