Font size is too large for display, text cut off on ESP S3 Box 3

[sammcj]

Willow-Mistral.mp4

I went to change the font in the configuration but found that it's hard coded to use a binary file that doesn't seem to have any source / build config:

   lv_font_willow = lv_font_load("A/spiffs/user/font/tonnelier.bin");

Ideally I'd like to make sure the font doesn't render outside the display, but also make it quite a bit smaller.

[stintel]

We've made a change in Willow Application Server to sanitize the response from command endpoints: HeyWillow/willow-application-server@5f3fe38. If you run WAS with this change included, and enable WAS Command Endpoint in WAS > Configuration > Advanced, this should solve the issue in the video.

[stintel]

We have just released WAS 0.2.0-rc.2 which includes the aforementioned change. Please test and close this issue if that solves the problem for you.

Thanks!

[sammcj]

Howdy @stintel, Thanks for looking into this.

Just tested out WAS 0.2.0-rc.2 with both current stable and 0.3.0-rc2 firmware and unfortunately it's no different - the font size is still quite large and scrolls off the screen (very laggy scrolling too?).

I'm just rushing out but I'll take some photos tomorrow.

[sammcj]

Actually - to correct myself after another reboot it did update!

It is better at least for short response but if you're getting it to tell you a few sentences the text is still so large it has to scroll for a very long time.

[sammcj]

Is the font, typeface size, background colour and basic text layout configurable by the user somewhere?

In a perfect would I'd like to get rid of the 'welcome to willow' and 'i heard:' and simply have what it heard at the top in small text, then the response (without the word response:) across 2-4 lines

[stintel]

We're an audio device first. We keep the UI very simple because we don't want to spend a lot of time on it. For the same reason, we don't support customizing it, and it's not planned either.