Hello, having some issues with the beta build of the front panel firmware. I have the front panel connected via qwiic cable to a BlueSCSI V2 - 2023.09a. Seems like the front panel and the BlueSCSI board aren't communicating. The front panel powers up, goes through its init sequence, but all it displays is "No Image Loaded". Button presses don't do anything. If given enough time for the screen to blank, button presses do wake it up.
I've tried flashing the RPi with the nuke firmware, then the panel firmware, no change. The BlueSCSI behaves normally otherwise. Change between various firmwares works as expected, but no change in behavior for the front panel.
Connecting through WiFi to the front panel works, but most of the details that would have come from the main BlueSCSI are blank or unknown. E.g.
System Information
Product: BlueSCSI Front Panel
Main firmware: Unknown
Front panel firmware: v0.4.0
Host Communications: Not initialized - Disconnected
Free Memory: 103.2 KB
Uptime: 4:53
System details
INI File
[SCSI]
EnableFrontPanel=true
Output log file
Platform: BlueSCSI (Pico1)
FW Version: 2026.04.28-dev Jun 18 2026 00:10:08
Flash chip size: 2048 kB
I2C Supported
=== Bootloader Log ===
[1ms] Bootloader version: Jun 18 2026 00:09:56 BlueSCSI
[1ms] Looking for firmware: BlueSCSI_Pico_DaynaPORT*.bin
[97ms] Bootloader continuing to main firmware
=== End Bootloader Log ===
Reclock RP2040 & Pico 1/1W based boards to standardized speed
Initial Clock set to 125MHz
Reclocking the MCU to 203MHz
Setting the SDIO clock to 41MHz
After reclocking, system reports clock set to 203MHz
=== SD Card Info ===
SD card detected, exFAT volume size: 121976 MB
SD Name: SD128, MID: 0x03 (SanDisk), OID: "SD" (0x53 0x44)
-- EnableFrontPanel = Yes
=== Global Config ===
Reading configuration from bluescsi.ini
-- EnableFrontPanel = Yes
=== Finding images ===
=== Finding images in / ===
== Opening /CD6-win95a_upg_en.iso for ID:6 LUN:0
---- Configuring as CD-ROM drive
== Platform supports ROM drive up to 800 kB
=== Configured SCSI Devices ===
ID: 6, BlockSize: 2048, Type: Optical, Quirks: Apple, Size: 615056kB, Removable
Hello, having some issues with the beta build of the front panel firmware. I have the front panel connected via qwiic cable to a BlueSCSI V2 - 2023.09a. Seems like the front panel and the BlueSCSI board aren't communicating. The front panel powers up, goes through its init sequence, but all it displays is "No Image Loaded". Button presses don't do anything. If given enough time for the screen to blank, button presses do wake it up.
I've tried flashing the RPi with the nuke firmware, then the panel firmware, no change. The BlueSCSI behaves normally otherwise. Change between various firmwares works as expected, but no change in behavior for the front panel.
Connecting through WiFi to the front panel works, but most of the details that would have come from the main BlueSCSI are blank or unknown. E.g.
System details
INI File
Output log file